Folding The Chair - bebeduE ROLLOWER Manual Del Usuario

UK
FITTING THE CONNECTORS
Fix the two connectors to the chair structure, leaving the straps inside. (Fig. 11)
Tighten the strap around the tube and turn the safety screw until the connectors
are properly fixed to the chair structure. (Fig. 12)
Make sure the two connectors are fitted at the same height. (Fig. 13)
Take the platform with the clamps now assembled and couple them to the connec-
tors, pushing the tabs outwards. (Fig.14, A and B)
Adjust the height depending on the pushchair model, pushing the adjustment
buttons fitted on the two clamps (Fig. 15).
Once you have found the correct position, you can now tighten the two safety
screws on the back of the platform (Fig. 16).
The Rollower platform is now assembled and properly coupled to the pushchair
(Fig.17).
FOLDING THE PLATFORM
To fold the platform when it is not in use, take the holding strap included and fit
it to the side tube of the chassis (Fig.18). Then pass it under the wheel and finally
introduce the hook into the fixing hole. (Fig. 19)

FOLDING THE CHAIR

WARNING: before folding the pushchair, always dismantle the platform.
If the connectors do not prevent the pushchair being folded up and unfolded, you
can leave them fixed to the tubes. (Fig. 20)
MAINTENANCE
Clean the plastic parts with a damp cloth.
Never use abrasive products.
Clean the sand and dust off the wheels.
Always dry the metal parts to prevent rusting.
NEVER BRING THIS PRODUCT CLOSE TO FIRE.
16