Installing The Crossover - Orion CO400C Manual De Usuario

Step 5: Install tweeter in flush mount housing.
Step 6: Connect the speaker wires observing the correct polarity.
Step 7: Install tweeter and housing in the hole cut for mounting, so that the trim ring is flat
with the front of the surface.
Step 8: Use the supplied pressure ring to secure the housing to the surface.
Figure 5
Figura 5
Abbildung 5

INSTALLING THE CROSSOVER

Step 1: Find a location for the crossover away from any factory or after market electrical wires.
It is recommended to mount the passive crossover close to the amplifier.
Step 2: Mount the crossover using the supplied wire ties.
Step 3: Connect the wires. Make sure the speaker wires for the midrange go to the mid/
woofer output and the tweeter to the tweeter output. Be sure to observe the correct
polarity. Changing the polarity of the tweeter may be necessary for optimum sound
quality.
6
Flush Mount Tweeter
Tweeter Cup
Assembly
Flush Mount Tweeter
Trim Ring Wire
Pressure
Ring
Wiring
Harness
Panel
@2012 MD Audio Engineering-all rights reserved