Installtion; Location; Reversing The Door Swing - Saivod FSM614W Manual De Instrucciones

2. INSTALLTION

2.1 Location

When selecting a position for your unit you should make sure the floor is flat and firm,
and the room is well ventilated with an average room temperature of between 16℃
and 38℃. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator.
Also avoid direct sunlight as it may increase the electrical consumption. Extreme cold
ambient temperatures may also cause the unit not to perform properly. This unit is not
designed for use in a garage or outdoor installation. Do not drape the unit with any
covering.
When installing the unit, ensure that 40 cm of free space is left at both sides, 15 cm at
the rear and 20 cm at the top of the unit. This will allow cold air to circulate around
the wine cooler and improve the efficiency of the cooling process. The door can be
opened to the right or the left, depending on what better suits the location. Please
ensure there is adequate space for the door to fully open.

2.2 Reversing the Door Swing

Tools Required: Phillips style screwdriver / Flat blated screwdriver / Hexagonal
spanner
◆ If you want to have the door swing reversed, we recommend that you
contact a qualified technician. You should only try to reverse the door
yourself if you believe that you are qualified to do so.
◆ Ensure the unit is unplugged and empty.
◆ Adjust the two levelling feet to their highest position.
◆ To take the door of it is necessary to tilt the unit backwards. You should rest
the unit on something solid so that it will not slip during the door reversing
process.
◆ All parts removed must be saved to do the reinstallation of the door.
◆ Do not lay the unit fat as this may damage the coolant system.
◆ We recommend that 2 people handle the unit during assembly.
1) Remove the plastic covering from the top door hinge.
2) Unscrew the three screws from the bottom bracket.
Remove the foot from opposite side.
11