auna multimedia RTT 1922 Manual De Instrucciones página 19

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

The system is able to decode and playback all MP3 file which stored in the memory media with USB con-
necting port.
Insert any USB drive into the USB slot without using force. Make sure you insert it in the right way.
Connecting the USB upside down or backwards could damage the audio system or the storage media.
Check to be sure the direction is correct
The system will start reading the storage media automatically after connecting, and LCD display (1)
will show the total number of MP3 files and total number of folder being detected.
Use
/
,
ned on the USB drive.
Remarks
The system can detect and read the file under MP3 format only though the USB port.
Due to MP3 encoding variances, some MP3 players might not be able to play via the USB socket. This
is not a system malfunction.
Remove the stylus protector. Make sure that the tone arm is being detached from the tone arm rest before
operating and is re-secured again afterwards.
Set the function selector (6) to PHONO.
Set the speed selector to the proper position depending on the record to be played.
Place the record on the platter (use the spindle adaptor if required).
Lift the tone arm from the rest and slowly move it to the record side. The platter will start to rotate.
Place the tone arm to the desired position of the record.
Adjust the volume to the desired level.
At the end of record, the platter will automatically stop rotating. Lift the tone arm from the record
and return it to the rest.
To stop manually, lift the tone arm from the record and return it to the rest.
Remark: as some kind of record the auto-stop area was out of the unit setting, so it will stop before the last
rack finish. In this case, select the auto-stop switch (25) to "off" position, then it will run to the end of the
record but will not stop automatically (turn off the unit by power button or switch back the auto-stop switch
to ON position to stop the platter rotate). Then put back the tone arm to the rest position.
/
and the FOLDER UP/DOWN buttons to navigate through the tracks contai-
Phono Deck
USB
19

Publicidad

Tabla de contenido
loading

Tabla de contenido