Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Encoding/Copying LPs and CDs to Digital Audio (MP3)
CD -> MP3
Encoding 1 track
•
Perform normal playback of the CD track you want to encode & record,
•
Press REC button (15) during the playback of the desire track, unit will display
Encoding is performing now.
•
After completing of encoding, unit will stop playback automatically.
Encoding whole disc
•
Place a CD with the printed side facing up inside the tray & then close the CD door
•
Press REC button (15) after focus search completed. Unit will display
is performing now.
•
After completing of encoding, unit will stop playback automatically.
Encoding by playlist
•
Place a CD with the printed side facing up inside the tray & then close the CD door
•
Select the desire tracks by following "CD disc programming" procedures. Then press PLAY/PAU-
SE (12) to start playback.
•
During CD playback, press and hold the " CD play/pause/stop " button (12) for 2 seconds to enter
the stop mode.
•
Press the " RECORD " button (15) and the unit will display
now.
•
After completion of encoding, the unit will stop playback automatically
Remarks:
•
The recording speed is 1:1 and according to the actual plying time of the CD track
•
The system will create a " Audio " folder and then store the encoding track in it.
•
The recording format is preset at – MP3 bit rate : 128 kbps, sampling rate : 44.1khz
•
No song title will be recorded during encoding mode
•
To interrupt the recording, press the " record " button again during record mode
•
Recording will be completed only if an entire song is being encoded. If you terminate the encoding
process intermediately, there is no track being recorded nor stored to the USB storage.
Copying MP3 files
If you insert an MP3 disc instead of an audio CD, the system will copy the files to an inserted USB drive when
you press the REC button. The operation procedure is the same as CD encoding (see above), and the system
will switch to copy mode only if MP3 file being read.
Phono -> MP3
•
Set the function button to " Phono " mode and then press the " Record " button (15) directly.
•
The LCD display with show the word "USB" and then flashing, and then display
after few seconds. Now the system is starting the encoding mode.
20
&
&
flashing. Encoding
&
- Encoding is performing
&
and flashing
flashing.
Publicidad
Tabla de contenido
