System Reset - D-Link DIS-700G-28XS Guía De Instalación Rápida

DIS-700G-28XS Industrial Layer 2+ Gigabit Managed Switch with 10G SFP+ slots Quick Installation Guide
Connect & Log in to the DIS-700G-28XS
1. Connect to the console port on the DIS-700G-28XS.
2. Navigate to the switch's default IP address: 10.90.90.90
3. Log in using the default user name and password.
User name: admin
Password: admin
CLI Initialization & Configuration (Optional)
1. Connect to the Console port on the DIS-700G-28XS.
2. Enter the command: telnet 10.90.90.90
3. Log in using the default user name and password.
User name: admin
Password: admin
4. Change the IP address using the commands listed below:
CLI Command:
enable
configure
interface vlan 1
ip-address xxx.xxx.xxx.xxx netmask xxx.xxx.xxx.xxx
exit

SYSTEM RESET

In the unlikely event that the switch is not responding or is experiencing problems, press the reset button to
reboot the system.
7