Electric Start; Manual Start - PowR-Quip Contractor Serie Manual De Instrucciones

ELECTRIC START

Fill the engine with 1 L of SAE-10W-30 oil, then
1
check the oil level until it marks just below "F". A
funnel must be used to do this. Do not exceed the
maximum capacity of 1.1 L.
2
Fill the 6.6 gasoline tank
w i t h a c l e a n , n e w 9 0
octanes or higher unleaded
gasoline. A funnel must
be used to avoid gasoline
spills near hot areas. It
is recommended to pour
no more than 6 gallons
of gasoline due to gases
produced by gasoline when exposed to higher
ambient temperatures.
Move the choke lever to
3
the left to let the engine run
at full speed (3600 rpm).
T u r n t h e k e y
4
a t t a c h e d t o t h e
electric start to the
right all the way to
the "Start" position
and hold it for about
2-4 seconds. If the
engine does not
start repeat the process no more than 5 times in
30 minutes.
Move the choke lever to
5
the right.
22
All manuals and user guides at all-guides.com
QUICK START GUIDE

MANUAL START

Follow the steps for electric start, except step 4.
Pull the recoil cord one
4
time with a slow and
controlled move to make
sure there are no knots.
Make a quicker, stronger
pull to turn on the engine.
Repeat this procedure as
necessary.
REMOTE CONTROL - ON&OFF BUTTON
To start your generator, it is
necessary to turn the key switch to
A
the "ON" position
Button A / ON button - Keep it
pressed for 5 seconds or until the
generator starts.
B
Button B / off button - Keep it
pressed for 5 seconds or until the
generator stops.
No. CODE
1 AC-CRG REMOTE CONTROL
BATTERY HOLDER
Tools required: 7/16" and 1/2" wrenches
1
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
DESCRIPTION