Installing The Card Reader - Dynex DX-CRD12 Guia Del Usuario

6

Installing the card reader

Changing the front bezel
To change the front bezel:
1 Use a stylus or pen-like tool to press the plastic clip on each side of your card reader to
remove the old bezel.
2 Snap the new bezel into place.
Installing your card reader
USB pin cable assignment
Make sure that your computer's system board connector is compatible with your card reader's
USB connector by comparing your card reader's USB connector with the connector on your
computer' s system board.
Card reader connector
Pin
P5
P4
P3
Plastic clip
P5
P1
Cable color
Shield GND
Black GND
Green D+
Installing the card reader
Function