Installing The Driver - Dynex DX-CRD12 Guia Del Usuario

8
7 Secure your card reader to the drive bay with the four mounting screws (two screws
per side).
Screw
8 Connect your card reader' s USB connector to a compatible USB connector on your
computer' s system board.
9 Make sure that you have removed any tools or loose screws from inside your computer,
then replace your computer' s cover.
10 Reconnect your computer' s power cord, then turn on your computer.

Installing the driver

Windows XP or Windows 2000
Windows XP and Windows
®
After you install your card reader and turn on your computer, Windows installs the correct
driver, and four new drive icons appear in the My Computer and Windows Explorer windows.
Note: The T-Flash and the MMC/SD slots share the same drive icon.
Installing the card reader
2000 have built-in drivers. You do not need to install a driver.
®
Screw