Premier CH-4174VS Manual De Instrucciones página 10

!
!
CAUTION
The fireplace need to be installed in a dry, safe and dustless
place.
f there's no!73._7"`J!socket near the desired location, install a new one
IV. I
nearby
.
WARNING
Do not attempt to wire you own new sockets or circuits. To
reduce the risk of fire, electric shock or injury to persons, always
use a licensed electrician.
V. Make sure the fireplace insert is switched off (refer to operation
instruction section).
VI. Plug the fireplace into a 73._7"`J socket. Wiring the cord along the
corner of wall.
Control the Electric Fireplace
A. Buttons and indicators
There are four buttons on the remote controller, and four on the
control panel of the fireplace, each pair of buttons with the same
label perform the same function:
<ON/OFF> button is power switcher of the electric fireplace;
<DIMMER> button is used to adjust the brightness of simulated flame
and logs;
<LOW> button turns the heater on and switches it to low-power
status. If the heater already is, turn it off;
<HIGH> button turns the heater on and switches it to high-power
status. If the heater already is, turn it off;
!
!
!
There are four indicators on the
control panel:
is the power indicator, it
light up when the fireplace
is working, and turned out
when the fireplace is
turned off;
indicates the status of the
simulated flame and logs. It's brighten up when the flame simulate
component is working, and will be flashing when you adjusting the
brightness of the flame;
indicate the heater is working in low-power status;
indicate the heater is working in high-power status.
The red window on the control panel of fireplace is the eye of receiver, do
not cover.
B. Operation
On the first usage of remote controller, install the batteries first: open the
battery box by sliding its cover along the arrow, install two AAA batteries
according to the marks in the box, and slide the cover to its original
position. If no batteries installed or the batteries are failure, the remote
controller will be unusable.
To use the remote controller effectively, point it to the electric fireplace
and keep a distance of 1-5 meters.
There're four buttons marked the same as buttons on the remote
controller, each pair of them perform the same function, choose as you
favour.
1. Power control. Press the <ON/OFF> button, the electric fireplace
will be powered on, and the
not be turned on automatically when you power on the fireplace,
please refer to paragraph 3. Note, all operations are valid only
7M! !
lamp will brighten up. The heater will
"`!