Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
!
!
QUICK REFERENCE GUIDE
I.
Prior to installation, please ensure:
1.
The rated voltage of your firebox fits the output voltage of your
socket;
2.
The light bulbs in your firebox is in good condition. For checking
this, please follow the instructions for replacing the light bulbs
on section MAINTENANCE.
II.
The heater on your fireplace may emit a slight, harmless odor when
first used. This odor is a normal condition caused by the initial
heating of internal heater parts and will not occur again.
III.
If your heater does not emit heat, please ensure the Heater Switch is
on. For further information, please consult section Operation of the
Practical User's Guide.
Marks
NOTE
Procedures and techniques, that are considered important enough to
emphasize.
CAUTION
Procedures, which if not carefully followed, will result in damage to the
equipment.
WARNING
Procedures, which if not carefully followed, will expose the user to the
risk of serious injury, illness or death.
!
!
!
IMPORTANT INSTRUCTIONS
WARNING
You should read and always follow the important instructions below to reduce the
risk of fire, electric shock, and injury to persons.
Do not modify this fireplace. Use it only as described in this manual. Any other
•
use not recommended by the manufacturer may cause fire, electric shock or
injury to persons.
Avoid the use of an extension cord because the extension cord may overheat
•
and cause a risk of fire. However, if you have to use an extension cord, the cord
shall be 16AWG minimum size and rated not less than 125V/15A or 2000 watts.
Do not burn wood or other materials in this fireplace.
•
If the supply cord is damaged, it must be replaced by a special cord or assembly
•
available from the manufacturer or its service agent.
Do not strike fireplace glass.
•
Always use a certified electrician should new circuits or outlets be required.
•
Always use properly grounded, fused and polarized outlets.
•
Always use ground fault protection where required by electrical code.
•
The heater must not be located immediately below a socket-out.
•
Always disconnect power before performing any cleaning, maintenance or
•
relocation of the fireplace.
When transporting or storing the fireplace and cord, keep in a dry place, free
•
from excessive vibration and store so as to avoid damage.
WARNING: In order to avoid overheating, do not cover the heater.
•
This appliance is not intended for use by persons (including children) with
•
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
•
Indoor and household use
•
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal
•
cutout, this appliance must not be supplied through an external switching
device, such as a timer, or connected to a circuit that is regularly switched on and
off by the utility.
Read all instructions before using this fireplace.
•
This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot
•
surfaces, such as surfaces near the heater outlet or light bulbs. The grill directly
in front of the heater outlet becomes hot during heater operation. Keep
combustible materials, such as clothes, pillows, furniture, bedding, papers and
curtains at least 3 feet from the front of the unit. Do not cover or block heater
outlet or any ventilation or exhaust opening at any time. Do not use on soft
surfaces where openings may become blocked.
73!
!
75!
Publicidad
Tabla de contenido
