LUND 300068 Instrucciones De Instalación

For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-241-7219.
Important Safety Information
WARNING:
CAUTION:
Contents
Note: Not all fasteners are used in every kit.
M8-1.25 x 20MM
Thread forming
Tools Required
Socket Set
Metric
Preparation Before Installation
1. Park your vehicle in a clean, level location. Check to make sure the vehicle is in park, or for
manual drive models, place the transmission in first gear. Engage the parking brake.
2. Chock one wheel on both sides with wheel chocks.
3. Unpack the bracket kit and identify the parts according to the content descriptions above.
Installation Instructions
Lund EZ Bracket
• To be used with Lund branded products only.
• Do not stand on Lund running board or bracket while vehicle is in motion.
• Do not exceed 350 lbs. weight on the Lund EZ bracket system.
• Do not use the Lund EZ bracket system as a jacking point for vehicle.
• Do not use Lund EZ bracket system or running boards to fasten cargo.
• Periodically check all components for tightness.
• Be sure to wear safety glasses while installing Lund EZ bracket system.
• When using power tools read and understand all operating instructions.
M8-1.25
M8-1.25
U-NUT
X4
X8
Wrench Set
Metric
TM
M8
X8
X16
Safety Glasses
Page 1 of 4
300068
Kit #
10397
Rev B
1204
X8
Wheel Chocks