Inserting The Sd Card; Standby Mode - Optelec ClearReader+ Manual Del Usuario

Optelec
Note: In case a not by Optelec supplied SD card or a USB memory stick is being used for
saving documents, please remove the SD card and / or USB stick from the ClearReader
the start-up process. The ClearReader
stick is inserted. As soon as the ClearReader
inserted again.
3.3

Inserting the SD card

To be able to save documents with the
Magnification Feature Pack, insert the
supplied SD card into the SD slot
above the USB port on the right-hand
side of the ClearReader
you can use a USB memory stick to
save documents.
3.4

Standby mode

+
The ClearReader will go into standby mode if no button is pressed for 15 minutes on batteries
and 30 minutes if connected to mains power. The standby sound will be played, the Power
indicator will start blinking and the ClearReader
+
ClearReader from standby, press the Power button. When the batteries are fully charged, the
standby time of the ClearReader
will power down. Please note that switching to standby mode takes approximately 8 seconds
English
+
may not start properly if a not Optelec SD card or USB
+
. Alternatively
+
is approximately 40 hours. After 40 hours the ClearReader
+
is started up, the SD card or USB stick can be
+
will go into standby mode. To wake up the
+
ClearReader
+
during
+
Page 9