Care And Cleaning - Kohler K-102 Guía De Instalación Y Cuidado

Installation
With help, remove the bath from its carton and place it on top of
the protective floor covering.
Lift the outlet end of the bath until sufficient clearance is obtained
to attach the two front legs.
Insert the fastening bolt through the two washers.
With the load lug resting on the flat of the interior leg, align the
leg with the attachment lug.
Insert the fastening bolt, then wrench tighten.
Repeat the above procedure for the remaining legs.
Once the bath is placed into position with the drain connected,
verify the bath is level and resting on all four legs.
Adjust for Level
Turn the leveling bolts at the bottom of the four legs or place
metal shims under the bath legs to achieve level.

Care and Cleaning

For best results, keep the following in mind when caring for your
KOHLER product:
• Use a mild detergent such as liquid dishwashing soap and warm
water for cleaning. Do not use abrasive cleaners that may scratch
or dull the surface.
Kohler Co.
Bath
Load Lug
Fastening Bolt
Flat Washers (2)
Attachment Lug
Leveling Bolt
3 1123884-2-B