INIM Electronics PREVIDIA MAX IFMNET Manual De Instrucciones página 6

1. Inside the compartment, find the position of the module that corresponds to one of the connectors on the PCB bar.
If you are installing an IFM24160 power-supply module, you must use the first connector at the top. When installing
any other type of internal module, you can use this or any other connector that is free.
2. Position the module in such a way that it is on level with the desired connector on the bar hen insert it in place
by pushing it carefully to the left.
3. Affix the module to one of the holes on the grounding bar using one of the supplied screws.
4. Complete the wiring on the internal module.
4 Wiring
Refer to Figure 3 - Net, page 2.
The connection of two or more control panels in a Hornet+ network can be achieved by means of two RS485
communication ports (paragraph 2 - [C] - [D]).
Cables:
2 wire shielded cable
Typical impedance 12Ohm
Maximum length 1000m (between two successive control panels)
Compliant with local laws and regulations in force
The connection must be a loop connection and must respect the direction of the wiring: the terminals on the
terminal board of PORT-B must be connected with their counterparts on the terminal board of PORT-A of the next
control panel; whereas, the terminals on the terminal board of PORT-A must be connected to their counterparts on
the terminal board of PORT-B of the previous control panel.
Directive 2014/53/EU
compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. This product may be used in
all EU Countries.
Documents for the users
concerning to INIM Electronics S.r.l. products may be downloaded free of charge from the web address www.inim.biz, getting
access to Extended Access and then selecting "Certifications" or requested to the e-mail address info@inim.biz or requested by
ordinary mail to the address shown in this manual.
Manuals may be downloaded free of charge from the web address www.inim.biz, getting access to Extended Access and then
selecting "Manuals".
WEEE
countries with differentiated waste collection systems)
The crossed-out bin symbol on the equipment or on its packaging indicates that the product must be disposed of
correctly at the end of its working life and should never be disposed of together with general household waste.
The user, therefore, must take the equipment that has reached the end of its working life to the appropriate civic
amenities site designated to the differentiated collection of electrical and electronic waste.
As an alternative to the autonomous-management of electrical and electronic waste, you can hand over the
equipment you wish to dispose of to a dealer when purchasing new equipment of the same type. You are also
entitled to convey for disposal small electronic-waste products with dimensions of less than 25cm to the premises
of electronic retail outlets with sales areas of at least 400m2, free of charge and without any obligation to buy.
Appropriate differentiated waste collection for the subsequent recycling of the discarded equipment, its treatment and its
environmentally compatible disposal helps to avoid possible negative effects on the environment and on health and favours the
re-use and/or recycling of the materials it is made of.
Copyright
may be copied without written authorization from INIM Electronics s.r.l. All rights reserved.
6
Hereby, INIM Electronics S.r.l. declares that these Previdia Max control panels are in
Declarations of Performance, Declarations of Conformity and Certificates
Informative notice regarding the disposal of electrical and electronic equipment (applicable in
The information contained in this document is the sole property of INIM Electronics s.r.l. No part
IFMNET
Wiring