Nice TTP Instrucciones Y Advertencias Para El Uso página 9

4.8) Programming the rain intervention direction
You can quickly change the direction of movement in the event of intervention of the rain sensor by following the procedure described in Table
20.
Table 20 Selecting the rain intervention direction
1. Press the key to reverse the rain intervention direction.
2. The green OK LED starts flashing: press OK within 3 seconds to confirm.
4.9) Enabling/disabling the sensors
This key is for enabling/disabling the intervention of the automated sun and rain systems. If the function is activated the respective LED lights
up, otherwise it remains OFF.
Table 21 Enabling/disabling the automated sun and rain systems
1. Press the key to enable/disable the sensors.
2. The green OK LED starts flashing: press OK within 3 seconds to confirm.
4.10) Cancelling the parameter memory
This procedure enables you to cancel all the parameters stored in the motor memory and restore the factory settings.
Table 22 Cancelling the parameter memory
1. Hold down the 'Cancel' key (bin) for about 3 seconds until the respective LED starts flashing.
2. The green OK LED starts flashing: press OK within 3 seconds to confirm.
Note: this procedure does not cancel the radio controls; for this function see paragraph 4.13) Cancelling all radio controls.
4.11) Entering the radio controls
You can quickly enter a radio control by following the procedure described in Table 23.
Table 23 Entering a radio control
1. Press the 'Save radio control' key. The LED above the key will start flashing slowly to
indicate that the unit is waiting to receive a radio control.
2. Within 5 seconds press any key on the radio control to be entered.
3. If the radio control is received correctly, the LED on the key flashes quickly.
4. The green OK LED starts flashing: press OK within 3 seconds to confirm.
4.12) Cancelling a radio control
You can quickly cancel a memorized radio control by following the procedure described in Table 24.
Table 24 Cancelling a radio control
1. Press the 'Cancel radio control' key. The LED above the key will start flashing slowly to
indicate that the unit is waiting to receive a radio control
2. Within 5 seconds press any key on the radio control to be removed.
3. If the code is received correctly the LED on the key flashes quickly.
4. The green OK LED starts flashing: press OK within 3 seconds to confirm.
GB
Example
3s
Example
3s
Example
3s
Example
5s
3s
Example
5s
3s
9