Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7
7C
7 CONTROL BODY INSTALLATION
Place Putty Ring (7A) to Control Body (7B). From above sink, insert Threaded Stud
(7C) and Hoses (7D) through any hole of sink.
8
8B
8C
8 SECURING CONTROL BODY
From underneath sink, secure Control Body (8A) by placing Metal Washer (8B) and
7
threading Long Nut (
/
'' Hex.) (8C) onto Threaded Stud (8D). Make sure that the
16
bumps on Metal Washer (8B) are facing up. Tighten loosely, make sure Handle (8E)
swings equally in both directions. Firmly hand tighten Long Nut (8C). Secure Long Nut
1
(8C) not to exceed a
turn.
/
4
Caution: Do not over tighten!
ENGLISH
7B
7A
7D
8E
8A
8D
9
9A
9 QUICK CONNECT & WEIGHT ATTACHMENT
Insert the end of the Pull-Out Hose (9A) into the Weight (9B). Screw Quick Connector
(9C) to the free end of Pull-Out Hose (9A).
10
10C
10A
10 PULL-OUT HOSE ATTACHMENT
From underneath sink, push Quick Connector (10A), located on the end of the Pull-Out
Hose (10B) firmly upward onto the Receiving Tube (10C), until unable to push any further.
Pull down on the Quick Connector (10A). If the housing and the Inner Collect (10D)
separate slightly but do not pull off, the Receiving Tube (10C) quick connect is secure.
3
9C
9B
10C
10D
10A
10A
10B
Publicidad
Tabla de contenido
