Phocos MPPT100/30 Manual De Instrucciones página 14

NOTE: Connect the MPPT by following the steps described below to avoid installation problems.
EN
1
Please see Fig 1, 2 and 3 that show how to install the MPPT on a standard 35mm DIN Rail.
Make sure that the ventilation slits are unobstructed.
Mount Din Rail onto the vertical surface.
Mount MPPT in a way that ensures there is enough space below and above for the air to vertically flow
through the ventilation slots.
4
NOTE: Place the positive and the negative wires close to each other to minimize electromagnetic effects.
NOTE: Solar panels provide voltage as soon as exposed to sun light. Mind the solar panel manufacturer's
recommendations.
5
2
Connect the wires leading to the solar array with the proper polarity.
To avoid any voltage from the wires, first connect the controller,
then the solar array. Mind the recommended wire size (see table
in chapter Recommended wiring for MPPT100/30) .
Close the cover of solar side.
Open the cover at the battery side. Connect the wires leading to
the battery with the correct polarity. To avoid any voltage from the
wires, first connect the MPPT and then the battery. Mind the
recommended wire length (see table in chapter Recommended wiring
for MPPT100/30) .
Close the cover of the battery side.
9
3