FAR TC 0016 CI Manual Del Usuario página 35

ENGLISH
Using the clippers:
For hair:
• Your hair musty be clean and dry. Put the
required comb on the cutting head with the
teeth facing upwards and press down on the
clip located on the bottom metal edge of the
cutting head (see illustrations below). Make
sure the accessory is locked in position before
starting to cut your hair. Switch the appliance
on by flicking the On/Off switch upwards (to
the On position).
• It is recommended that you test the clippers on
a small area of hair first in order to familiarise
yourself with the different combs. The six
removable combs give you a cutting length
ranging from 3 mm to 13 mm.
GB-6
• Switch the appliance on by flicking the On/
Off switch upwards (to the On position). It is
recommended that you test the clippers on a
small area of hair first in order to familiarise
yourself with the different combs. Start with a
comb for a longer cut. Then move onto shorter
combs if necessary. The six combs can be used
for cuts between 3 mm and 13 mm. Move the
clippers slowly and against the grain. Hold the
clippers so the comb is as flat as possible.
• Use the setting dial for extra flexibility, so
you can shorten your hair gradually without
having to change accessories. Remove the
comb and use the cutting head on its own to
go round the edges. Switch the appliance off
immediately after use by flicking the On/Off
switch downwards (to the Off position).
• You can use the hanging hook on the cable for
easy storage.
ENGLISH
GB-7