Klarstein MANHATTAN Manual Del Usuario página 17

TROUBLESHOOTING
Problem Possible cause
The device is The voltage is too low.
exceptionally loud
and humming.
The water There is too little water
indicator goes on. in the tank.
The float has not been
installed correctly.
The float switch is
broken.
The indicators on The fuse is broken or the
the control panel unit is switched off.
do not light up.
The ice cubes are The water temperature
too large and stick is too low.
together.
There is ice from the last
run in the water bowl.
The device is Problem with the
running but does coolant.
not produce ice.
The compressor is
broken.
The fan motor is
damaged.
All lights flash Since ice has no contact
simultaneously. with the ice bar.
The moving detection
mechanism on the ice
bar is broken.
The ice reaches The movable detection
the ice bar but mechanism on the ice
the ice container bar is broken.
display does not
The display is broken.
start.
Suggested solution
Stop the unit and plug it into
an outlet that has the specified
voltage.
Top up with water.
Contact a specialist company.
Replace the fuse or switch on
the appliance.
Select small ice cubes.
Switch to standby mode and
remove the ice.
Contact a specialist company
for inspection and repair.
Disconnect the plug and restart
the appliance.
Contact a specialist company.
Contact a specialist company
for inspection and repair.
EN
17