Fin Assembly - Jobe E-DUNA SUP Manual De Instrucciones

Attach the fin to your board following the instructions in the pictures. Make sure the fin is pointing in the right
direction! Check the water's depth and make sure the fin is not obstructed. Check the weather and conditions.
Mounting the fin
The fin can be mounted before or after inflating the board.
1. Place the back of the fin with the pin into the mounting on the board.
2. Slide the fin backwards and push the front down.
3. Lock the fin by pushing the leve
WARNING
1
WARNING
- The seals of the Drive and its cover MUST be completely clean.
- Before putting the Drive in the board's opening, make sure once again that it is facing the right direction.
- Before attaching the cover make sure that nothing is obstructing the placement of the cover. Fasten the screws
manually to fingertight, without any tools or any other objects.
- There is no visible pressure gage, as inflation is automatic.
WARNING The leash MUST be worn at all times! It is also used to carry the board down to the water.
Always use a life-jacket and a leash while paddling.
DO NOT carry the board in such a way that it puts pressure on the Drive.
DO NOT purposefully overturn the board while in the water; if it is overturned by accident, immediately turn it
back over.

FIN ASSEMBLY

2
15
3