Precautions Before Use; Starting And Stopping - TOYAMA TA3.5CS2 Manual De Instrucciones

Three-phase double bearing (220V/380V)
Model TA15.0CT2 - 380
A 279
B 203
C 121
D Ø 42
E 100
G 37
H 180
K Ø 15
a 55
b 334
h1 25
h 495
L1 600
L2 365
g 44,8

4. PRECAUTIONS BEFORE USE

1. Connect the output cables to the connection board in the switch box of the generator.
The size of the cables must have cross-shaped pins of sufficient thickness to transmit
the current securely.
2. Open the outer shield of the back cover to verify that the power brushes are all in
normal use.
3. Switches and fuses of adequate capacity shall be attached to each terminal. Before
operating the equipment, the terminal switches must be facing left.

5. STARTING AND STOPPING

STARTING:
1. Set the switchboard field rheostat to short circuit by rotating the head so that it points
to the highest voltage.
2. Make the main motor start, when the speed of rotation reaches the nominal value, the
generator will immediately increase the voltage by its own excitation. Leave the speed
slightly above the speed to compensate for the drop-in speed when the machine is at
full load. In the meantime, adjust the field rheostat until you get the readout of the
voltmeter for 400v.
3. Turn the output switches to the normal power supply mode.
STOP:
1. Remove the loads from the terminals and turn off the switches.
2. Make the main motor stop.
3. Set the field rheostat to the short circuit position.
SPECIAL CARES:
1. Take care to avoid short circuit in the machine and the output terminals, as in any case
the rectifying elements may be damaged.
TA20.0CT2 - 380 TA38.0CT2-380
279
203
121
Ø 42
100
37
180
Ø 15
55
334
25
495
600
365
44,8
318
228
133
48
110
42,5
200
Ø 19
60
378
30
540
660
400
51,2
12