Kärcher 2.643-381.0 KM Medium Manual Del Usuario página 12

Figure 5: Plug (XA11)
Figure 6: Plug (X200)
Figure 7: Plug (X301)
12
1 Plug (X1A1)
2 Plug casing (XA11.1)
3 Plug (XA11)
Remove the plug from the circuit board and plug into

the plug casing (XA11.1) of the cable harness.
Attach plug (XA11) to the freed-up slot of the circuit

board.
Attach plug (X200) to the empty slot SENSOR1_3.

Attach plug (X301) to the empty slot X301.

Note
The connection of the cable harness to the circuit board is
now completed.
Reinstall the control unit and secure by means of 4

screws.
4
-
EN