Quoizel LWS3445E Manual Del Usuario página 3

STEP 1:
a. Unscrew the preassembled lock screws from the top of
fixture body and remove the fixture hood.
Note : Place a cloth or towel on the ground under the
work area to prevent loss of mounting hardware if
dropped.
STEP 2:
a. Carefully fit the post fitter of the fixture body over the
end of the post (not supplied), making sure the post
fitter is fully seated.
b. Mark the drill point for the 3 mounting screws using the
holes on the post fitter as reference.
c. After marking hole locations, remove fixture from post
and drill 1/16 in. pilot holes for screws.
STEP 3:
* Use Wire Connectors (supplied) to connect the wires.
a. Connect fixture ground wire
wire connector.
b. Connect the supply white wire
supply wire with wire connector.
c. Connect th e supply black (or red)
fixture supply wire with wire connector.
d. Wrap each connection with approved electrical tape and
carefully stuff all of the connected wires into the post.
STEP 4:
a. Coat the top 1 in. of the post with clear silicone caulk
(not supplied) and position the post fitter of the fixture
body onto the post.
b. Be sure to seat it completely, aligning the holes in the
fitter with the 1/16 in. pilot holes drilled into the post.
c. Secure using the mounting screws.
STEP 5:
a. Install correct bulbs referring to fixture markings and/or labels for maximum wattage.
2018 QuoizelInc.
to supply ground wire with
to the white fixture
wire to the black
GROUND WIRE
FROM SUPPLY
WHITE
FROM SUPPLY
BLACK (OR RED) WIRE
FROM SUPPLY
3
Fixture hood
Lock screws
Fixture body
Fixture body
Post Fitter
Post
GROUND WIRE
FROM FIXTURE
WHITE
FROM FIXTURE
BLACK
FROM FIXTURE
Fixture body
Post Fitter
Mounting Screw
Post