Frequently Asked Questions - Conceptronic CSPKBTTL Manual Del Usuario

Bluetooth pairing and connection
1. If the speaker has been connected with Bluetooth devices before, it will connect with the last Bluetooth
device automatically once it is turned on.
2. If the speaker has not been connected with Bluetooth devices before, it will enter pairing mode, click to
connect.
3. Other phones or tablets cannot be connected with the Bluetooth speaker when the speaker is already
connected with a phone or tablet.
4. The phone or tablet cannot be connected with the Bluetooth speaker if it is connected with other Bluetooth
devices. You should turn off your Bluetooth connection and connect your phone with the Bluetooth speaker
again.
Lamp function
Hold down the switch on the bottom of the speaker. Turn on the light by tapping the mesh on the top, and the
lamp will turn on to the dimmest setting. The brightness can be adjusted by tapping the top mesh, and there are
3 brightness grades: low brightness, intermediate brightness, and high brightness. Tapping the top mesh when in
high brightness will turn the light off.

Frequently Asked Questions

Questions
Repeated unsuccessful
pairing and connection
Muted or distorted
sound
Choppy music play
The indicator not
shining in Bluetooth
mode
Solutions
1.Check the speaker and make sure it is in searching state or reboot the
speaker.
2. Connection is difficult when there are too many Bluetooth devices
nearby. Turn off other Bluetooth devices.
3.Turn off the Bluetooth device that was connected with the Bluetooth
speaker last time, and reconnect the speaker.
1.Check the volume of your phone or the speaker, and adjust the volume.
2.The battery is low. Please charge it.
1. Check if the device is beyond the effective connection distance.
2. Check if there is any obstacle between the speaker and your device.
1.The battery is low. Please charge it.
2.Please reboot the speaker.