Protecting The Environment - Kreg Foreman DB210-EUR Manual De Instrucciones

13.
1. Test Pieces
Test the joint with scrap pieces cut from the same stock as
your final workpiece.
2. Make sure you're using Kreg Screws
Kreg screws feature sharp, self-tapping tips that slice through
the wood fibers instead of forcing them apart.
3. Use the Right Screw Type
Use fine-thread screws in hardwood. These #7 screws
displace less wood than the #8 coarse-thread screws used
for softwood, plywood, MDF, and particleboard.
Do not dispose of electrical tools with normal household waste. In compliance with European Directive 2002/96/EC on
waste electrical and electronic equipment and implementation in accordance with national law, electric tools that have
reached the end of useful life must be collected separately and returned to an environmentally compatible recycling facility.
EC DECLARATION OF CONFORMITY
We: Kreg Tool Company
declare in sole responsibility that:
Equipment: Pocket-hole machine
Model: DB210-EUR
to which this declaration applies, complies with these normative documents:
Machinery Directive: 2006/42/EC
and conforms to the following EN standards:
Low Voltage Directive: 2006/95/EC
EMC Directive: 2004/108/EC
EN 55014-1:2006+ A1:2009+A2:2011
EN 55014-2:1997+A1:2001+A2:2008
EN 61000-3-2:2006+A1:2009+A2:2009
EN 61000-3-3:2013
EN 61029-1:2009+A11:2010
The technical documentation is kept by Kreg Tool Company
Notified Body: TÜV Rheinland
Note: This declaration becomes invalid if technical or operational modifications are introduced
without the manufacturers consent.
Todd A. Sommerfeld, CEO
____________________________________________________________________________________
Name
6 Tips to reduce splitting

Protecting the Environment

Signature
Tips
4. Screw it In, Back it Out
Drive the screw half-way in, back it out to clear excess wood
fibers from the hole, and then drive the screw all the way in.
5. Reduce Friction
Apply bee's wax or other lubricant to the screw to reduce the
friction as the screw enters the workpiece
6. Clamp Correctly
Center the pads of your Kreg Face Clamp™ on the joint line
with the large clamp pad on the face side (opposite the pocket
holes) of the joint. Adjust the clamp to apply enough pressure
to keep the workpieces flush and stable but not so tight to
make clamping and unclamping difficult.
9/2/14 Huxley, IA, USA
Date and Place