Publicidad
Idiomas disponibles
Idiomas disponibles
TD3 - User manual
(A) Telephone sockets for connection to slave display,
console or Voice module;
(B) Function and codification key;
(C) Connection socket to 12 volts supply.
ATTENTION: Read this manual before using the product.
Installation unit: Put the metal holder to the wall and fix
the display. The length of the cable is approximately 2
meters.
Display configuration: Pressing shortly the push button
(B) on the backside the display will put to ZERO and
visualize:
1) 7 segment test (number
2) Beep tone test
3) Display codify (
4) Numbers presentation (
5) Acoustic tone mode (
6) Stand-by (
off,
Pressing the button (B) it's possible to go directly to
)
)
)
,
-mute)
on - 15 minutes)
e n g l i s h
point 3,4,5 and 6.
To modify the standard configuration choose the desired
codify (
) and release the button.
At each cycle correspond ONE codify. To program code
1 press the button until the display will show
codify the remote control. This function is useful when
there are two or more systems in the same area (e.g. in
a supermarket). After this it's possible to make another
codify. To set stand-by function press the button until
the indication
and then release it. In this way the
display will put off automatically after 15 minutes of inac-
tivity. At the next call from the remote it will visualize the
last number shown.
and
Publicidad
