Technical Data - Brill 430 BRW Guía De Uso

Technical data

Working width:
Roller diameters:
Weight: (without filling)
Filling quantity of sand:
Assembly
Fig. E
Before commencing with the
assembly, you can fill the lawn
roller with sand, thereby increas-
ing the weight. To do so, loosen
the left and right bolts (1) so that
you can remove the bushes (2)
and the hoop (4). Remove the
disk (3), the guide cover (5) and
the disk (6). When filling with
sand, ensure that the guide
cover remains on the other side
in the roller. Now position the
roller vertically and fill it with
dry sand.
Attaching to the Brillencio
Fig. C
For the attachment, the bolts (11)
and nuts (10) must be loosened
somewhat so as to enable
the clamping lugs (9) to be dis-
Protection of the environment, disposal
The packaging
material is made of
recyclable materials.
Dispose of packag-
Notes on these Operating Instructions
Adhere to the lawnmower's
instructions for use.
50 cm
22 cm
~ 13 kg
~ 29 kg
Now place the disk (6) on the
axle ( 7), followed by the guide
cover (5), now return the roller
to a horizontal position and
ensure that the guide cover does
not slip out of the roller. Place
the disk (3) on the axle (7), fol-
lowed by the hoop (4) and the
bushes (2) and then tighten them
in position with the screws (1).
Fig. A
With the Brillencio with the cut-
ting widths 41 cm and 43 cm,
mount the retaining hoop (8) on
the angle (5) in hole spacing A
(fig. D) using the bolts (11) and
placed. Attach the retaining
hoop (8) onto the cross strut on
the housing, push the clamping
lugs (9) under the cross strut,
retighten the bolts (11) with the
nuts (10).
ing materials in accordance with
regulations.
Please carefully read the operat-
ing instructions and adhere to
nuts (10). With the cutting
widths 48 cm and 51 cm, mount
the retaining hoop (8) in hole
spacing B (fig. D). The clamping
lugs (9) are mounted on the
retaining hoop (8) using the
bolts (11) and nuts (10).
Bolt the guide rod together using
the bolts (6) and the butterfly
nuts (7), pull the lower part of
the guide rod slightly apart (3)
and push the lower part of the
guide rod (3) right and left with
the drilled hole on the axis (13).
Secure the lower part of the
guide rod (3) with the securing
rings (12) fig. B.
Special care is to be taken when
working with an attached lawn
roller!
the general and safety instruc-
tions enclosed therein. Use this
GB
7