Fagor 3CC-239E X Montaje Y Modo De Empleo página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
Hood Description - Fig. 1
1. Light Switch
2. Motor Speed Switch
3. Light Covers - illumination of the Cooking
Surface
4. Grease Filters
5. Grease Filter Support Grate (the grease filters
are located inside).
6. Light Cover Supports
7. Pull-Out Drawer
Using the hood
The hood is provided with several speeds. For
the best performance, we recommend using the
low speeds in normal conditions and the high
speeds in particular cases of strong odour and
vapour concentration.
Pull out the drawer to access the control panel.
We recommend starting up the hood a few
minutes before cooking and keeping it running
until all the odours have been eliminated.
Model with Self-supporting Metal
Filters
Removing the Grease Filters - Fig. 2
a. Remove the pull-out drawer completely.
b. Press the side handles A towards the opposite
side and remove the filters.
Putting the Filters Back in Place
a. Remove the pull-out drawer completely and
mount the grease filter so that it covers the
drawer.
b. Close the drawer and install the remaining
grease filter.
Opening the Light Cover Support - Fig. 2
a. Remove the pull-out drawer completely.
b. Push the B knobs inwards toward each other
(in the "Open" direction as indicated on the
plastic knob itself).
Model with Grease Filter Support
Grates
Opening the Grease Filter Support Grates
- Fig. 3
a. Extract the pull-out drawer completely.
b. Push the B knobs inwards toward each other
(in the "Open" direction as indicated on the
plastic knob itself).
c. To remove the grates completely, use the N
spring fasteners, which act as pins to hold the
grate in place (Fig. 4).
GB
Maintenance
Before performing any maintenance operation,
isolate the hood from the electrical supply by
switching off at the connector and removing the
connector fuse.
Or if the appliance has been connected through
a plug and socket, then the plug must be removed
from the socket.
Metal Grease Filter
The metal grease filter serves to trap grease
particles by suspending them.
The metal grease filter lasts forever and must be
washed either by hand or in the dishwasher
(65°C) with suitable detergents.
The grease filters must be washed at least
once a month.
Let the filter dry without damaging it before putting
it back into place.
Removing the Grease Filters (for models
wtih grease filter support grates)
a. Isolate the hood from the electrical supply.
b. Extract the pull-out drawer completely.
c. Open the grates that support the grease
filters.
d. Remove the L fasteners for the grease filter
and remove it (Fig. 5).
When washing the grease filter, wash the grate
as well with warm soapy water.
Carbon filter
This filter dissolves cooking odours.
The carbon filter must never be washed.
It should be changed every 4 months in
normal use.
Mounting the carbon filter:
a. Isolate the hood from the electrical supply.
b. Extract the pull-out drawer completely.
c. Remove the grease filters and open the light
cover support (or the grease filter support
grates).
d. Install the charcoal filter so that it covers the
plastic grate which protects the ventilation fan
(Fig. 6).
e. Turn the center handle of the carbon filter in
the clockwise direction until it locks in place.
f. Refit the grease filters and the light cover
support (or the grease filter support grates).
Removing the carbon filter:
Turn the center handle of the carbon filter in the
counterclockwise direction and remove the filter
from its seat
12

Publicidad

Tabla de contenido
loading

Tabla de contenido