Connecting To Network - JetNet 4508 Guía De Instalación Rápida

Wiring the Digital Input (DI)
The Digital Input (D.I.) contacts are in the bottom side of the device as shown in Figure-4.
through Ethernet when the signal is changed.
Note: the DI accepts DC type signal and supports isolated input circuit with Digital High
Level input DC 11V~30V and Digital Low Level input DC 0V~10V. Do not apply voltage

Connecting to Network

1. Connecting the Ethernet Port: Connect the Ethernet port of JetNet 4508 series with
the other Ethernet device by Cat-5/Cat-6 UTP or STP cable, and then the LNK/ACT LED
2. Connecting the Fiber Port: Cross-connect the transmit channel at each end to the
receive channel at the opposite end as illustrated in the Figure-5.
ATTENTION
This is a Class 1 Laser/LED
product. Don't look into the
Laser/LED Beam.
Figure-4
Figure-5