Device Management - JetNet 4508 Guía De Instalación Rápida

Device Management

JetNet 4508 series Industrial Managed Switch provides both in-band and out-band
configuration methods. You can configure the switch via the RS-232 console with the
attached console cable. Or you can remotely manage the switch via network. You can
choose Telnet/SSH, Web/HTTPS management.
1. Preparation for console management: Attach the RS-232 DB9 connector to your PC's
COM port. Connect the RJ-45 connector to the console port of the JetNet 4508 Switch.
Go to Start -> Program -> Accessories -> Communication -> Hyper Terminal
Give a name to the new console connection.
Choose the COM name and select the correct serial settings. The serial port settings of
JetNet 4508 are as below: 9600bps, No parity check, 8 Data bits, 1 stop bit
After connected, you will see the Switch login request. Type the username and password and
then you can login. The default username is "admin", password is "admin".
2. Preparation for Web management: Before you attempt to use the embedded web interface
to manage switch operation, verify that JetNet 4508 is properly installed on your network and
that every PC on this network can access the switch via the web browser.
Launch the web browser (Internet Explorer or Mozilla Firefox) on the PC.
Type http://4508_IP_Address (The default IP address is 192.168.10.1.), then press Enter.
The login screen will appear next.
Type in the user name and password and click
"OK" button. The welcome page of the Web-Based
management interface will appear then. The default
user name and password is admin/admin.