Panasonic TY-ST58PF20 Instrucciones De Instalación página 20

Assembly
4. Setup and wiring of connected devices
Insert the five clampers
clamper attachment holes on the back side of the
left and right support columns at positions that
make wiring easy. Wire as shown in the figure.
Place cover stickers
the sides and back of the support columns and
other locations.
Note
Do not bundle the connection cables and main lead
together.
5. Preventing falling over
In order to prevent the unit from falling over, fix
the left and right support columns using strong
cords or wires passed between the top and
bottom brackets for plasma display, and connect
them without slack to sturdy pillars or walls.
(Use commercially available cord or wire to
prevent falling over.)
The distance between the pillar or wall and
the rear of the plasma display must be 1 m
(39.4 inches) or less.
[For safety reasons, always use the overturn/fall prevention accessories]
The equipment may overturn in the event of an earthquake etc. Therefore, always use the overturn/fall
prevention accessories.
* The details in this section indicate how to reduce any damage or injury caused by this equipment overturning or
falling due to an earthquake. However, there is no guarantee that the overturn/fall prevention accessories will
be effective in all earthquake situations.
20
in any of the six
in unused spare holes on
Clamper
Main lead and
various cables
Cover stickers
Strong cords or wires
available on the market
Main lead
and various
cables