Inflator Operating Instructions - BONAIRE DD22C Manual Del Usuario

INFLATOR OPERATING INSTRUCTIONS

CAUTION
To inflate vehicle and bicycle tires:
1. Remove 12 Volt Inflator from carrying bag.
2. Connect the 12 Volt power cord into DC 12 Volt power outlet. (Please see Image #5 below).
3. Connect the Quick Connect Valve Adaptor to tire air valve by pushing the valve lever down
until it is securely attached to the tire air valve.
4. Move the On/Off switch to "I" position and the inflator will begin to operate. Monitor the
PSI on the gauge to fill your item to desired pressure. Once you have reached the desired
air pressure, move the On/Off switch back to the "O" position.
5. If you over-inflate – press the Air Release Valve (D) to slowly release some of the air from
the item until you reach the desired pressure.
6. Remove the air hose from the tire by lifting up on the valve lever. You will then easily lift the
valve lever upward and it will easily release from the valve you were inflating.
7. Remove the 12 Volt power cord from the DC 12 Volt power outlet.
8. Allow unit to cool.
9. Return 12 Volt Inflator to the carrying bag. Store inflator attachments in the carrying bag.
To inflate sports ball, air mattress, pool toys, etc.:
1. Remove 12 Volt Inflator from carrying bag.
2. Connect the 12 Volt power cord into DC 12 Volt power outlet. (Please see Image #5 below).
3. Select the appropriate inflation accessory and insert onto end of the Quick Connect Valve
Adaptor. (Please see Image #6 below).
4. Insert the inflation accessory into desired item you are inflating.
5. Move the On/Off switch to "I" position and the inflator will begin to operate. Inflate your
desired item to the correct pressure and move the On/Off switch back to the "O" position.
6. If you over-inflate – press the Air Release Valve (D) to slowly release some of the air from
the item until you reach the desired pressure.
7. Remove inflation accessory from Quick Connect Valve Adaptor.
8. Remove the 12 Volt power cord from the DC 12 Volt power outlet.
9. Allow unit to cool.
10. Return 12 Volt Inflator to the carrying bag. Store your attachments in the carrying bag.
Image #5
DO NOT OVER-INFLATE ITEM BEING INFLATED.
FOLLOW MANUFACTURERS SUGGESTED PSI LEVELS
ON ITEM YOU ARE INFLATING.
Image #6
5
www.bon-aireindustries.com