Tabla de contenido
Publicidad
DESCRIPTION OF FUNCTIONS
1 Back Focus adjustment screw
If focus needs to be adjusted after the lens has been mounted, loosen the CS mount lock
screw ( 7 ) and rotate the Adjustment screw to adjust.
2 DC iris level adjust POT
Adjust DC iris level manually. Please use this POT with Auto iris mode SW (8) set to
position.
3 BLC (Back Light Compensation) mode switch
When strong light (sun, sky, illumination, etc.) is present behind
the object being photographed, the object will appear dark. In this
case, put this switch in the
4 BLC adjustment POT
Adjust BLC level manually. Please use this POT with BLC mode SW ( 3) set to the
position.
5 Sync mode switch
For setting the sync mode.
L.L.: Line Lock mode
INT.: Internal sync mode
6 Auto-iris output connector
For connecting the cable of an auto-iris lens. The pin assignment is following.
No.
DC.
1
CTRL- Vcc
2
CTRL+ NC
3
DRV+
4
DRV-
7 CS Mount lock screw
8 Auto-Iris mode switch
For switching the output from the auto-iris connector ( 6). Shutter speed is fixed at 1/50 sec.
when switch is set to
DC: To be set when using a non built-in auto-iris lens.
AES: To be set when using AES (Auto Electronic Shutter).
VIDEO: To be set when using an auto-iris lens with built-in amp.
9 Video output connector
Connected to the TV monitor with a coaxial cable.
0 Line phase adjustment POT
This POT is used to adjust the signal phase when the Sync mode is set to
A AC Power input screw less terminal block
B Power indicator
A red lamp is lit when the camera is working.
ZC-F10C2*7.p65
position.
ON
VIDEO
VIDEO
GND
or
position.
DC
VIDEO
15
DC
ON
OFF
ON
position.
L.L.
9/13/00, 9:04 PM
Publicidad
Tabla de contenido
