Cadet softheat EBHN500 Guía Para El Propietario

Ocultar thumbs Ver también para softheat EBHN500:

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

OWNER'S GUIDE
Features & Benefits
Whisper quiet operation and low surface temperatures
Filled with non-toxic, non-hazardous thermal fluid
Self-contained hermetically sealed element design requires no
plumbing, piping, or other water supply
Thermal fluid capacity offers better heat retention, which creates
less cycling and keeps more consistent room temperatures
Designed to reduce the effects of indoor allergens
7-year element warranty
IMPORTANT INSTRUCTIONS
WARNING!
Turn the electrical power off at the electrical panel
board (circuit breaker or fuse box) and lock or tag the
panel board door to prevent someone from turning
on power while you are working on the heater.
Failure to do so could result in serious electrical
shock, burns, or possible death.
When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock, and
injury to persons, including the following:
1. Read all instructions and labels before installing this heater.
2.
WARNING
A heater has hot and arcing parts inside. Do not install in
areas where gasoline, paint or flammable liquids are stored or
excessive lint or dust are present.
3.
WARNING
This heater is hot when in use. To avoid burns, do not let bare skin
touch hot surfaces. Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes and curtains away from heater.
4. To prevent possible fire, do not block air intakes or exhaust in
any manner. Do not use on soft surfaces, like a bed, where
openings may become blocked. Heaters must be kept clean of
excessive lint, dirt and debris. (See Maintenance Instructions).
SAVE THESE INSTRUCTIONS
Tel: 360-693-2505 www.cadetco.com P.O. Box 1675 Vancouver, WA 98668-1675
5. Risk of electrical shock. Do not insert or allow foreign objects to
enter any ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
6. Do not place heater below an electrical convenience receptacle.
7.
WARNING
Overheating or fire may occur. Do not install the heater behind
doors.
8. Use extreme caution when any heater is used near children or
invalids and whenever the heater is left operating unattended.
9.
WARNING
Do not operate after heater malfunctions or has been dropped
or damaged in any manner.
10.
WARNING
Risk of fire. Do not block heater minimum of 12 inches in front
and above, 6 inches on both sides.
11.Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electrical
shock, or injury to persons.
12.Verify that the electrical supply wires are the same voltage as
the heater. The heater must be grounded to the grounding
screw provided. If you need to install a new circuit or need
additional wiring information, consult a qualified electrician.
MODELS:
EBHN500
EBHN750
EBHN1000
EBHN1250
EBHN1500
EBHN500-8
EBHN750-8
EBHN1000-8
EBHN1250-8
EBHN1500-8
TOOLS REQUIRED
Phillips Screwdriver
Straight Screwdriver
Wire Strippers
Drill or Hammer
Level
Punch or Chisel
Drill Bits
Utility Knife
(4) Wood Screws
(3) Wire Nuts
(1) Strain Relief Connector

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Cadet softheat EBHN500

  • Página 1 OWNER’S GUIDE MODELS: EBHN500 EBHN750 EBHN1000 EBHN1250 EBHN1500 EBHN500-8 EBHN750-8 EBHN1000-8 EBHN1250-8 EBHN1500-8 Features & Benefits TOOLS REQUIRED Phillips Screwdriver Whisper quiet operation and low surface temperatures • • Straight Screwdriver • Filled with non-toxic, non-hazardous thermal fluid • Wire Strippers •...
  • Página 2: Installation Instructions

    ABOUT THE CADET SOFTHEAT ELECTRIC BASEBOARD: The Cadet Softheat Baseboard is designed to provide zonal heat to a room by using convection to naturally circulate warm air. Safety is Cadet’s first priority. All Softheat baseboards feature an oversized high temperature auto reset limit switch that shuts the heater off when excessive operating temperatures are detected.
  • Página 3 INSTALLATION INSTRUCTIONS READ ALL INSTRUCTIONS AND SAFETY STEP 1: Mount Heater to Wall STEP 2: Wiring Provisions / Wiring INFORMATION. 1. Locate wall studs closest to supply wires and position This heating unit is designed for permanent installation. heater (See Figure 1). NOTE: Wire connection is from All wiring should be routed in compliance with the left side only on standard models.
  • Página 4 STEP 3: Thermostat For best results, use a Cadet electronic wall thermostat or an EBKN end cap DPST thermostat kit. It is recommended that a thermostat be provided for each room. The location of the thermostat should be selected carefully.
  • Página 5: Troubleshooting Chart

    WARRANTIES Maintenance: For more effective and safer operation and to prolong 7. IN THE EVENT CADET ELECTS TO REPLACE ANY PART OF YOUR the life of the heater, read the Owner’s Guide and follow the maintenance CADET PRODUCT, THE REPLACEMENT PARTS ARE SUBJECT TO instructions included with each heater.
  • Página 6: Guía Para El Propietario

    GUÍA PARA EL PROPIETARIO MODELOS: EBHN500 EBHN500-8 EBHN750 EBHN750-8 EBHN1000 EBHN1000-8 EBHN1250 EBHN1250-8 EBHN1500 EBHN1500-8 HERRAMIENTAS NECESARIAS: Destornillador Phillips • Destornillador plano • Pelacables • Taladro o martillo • Características y Beneficios Nivel • Operación más silenciosa y bajas temperaturas en la superficie •...
  • Página 7: Instrucciones Para La Instalación

    ACERCA DEL ZÓCALO ELÉCTRICO SOFTHEAT DE CADET: El zócalo eléctrico Softheat de Cadet está diseñado para brindar calor zonal a una habitación usando convección a fin de hacer circular el aire caliente en forma natural. La seguridad es la principal prioridad de Cadet. Todos los zócalos Softheat incluyen un interruptor límite de alta temperatura y gran tamaño con restablecimiento automático que apaga el calentador...
  • Página 8 INSTRUCCIONES PARA LA INSTALACIÓN LEA TODAS LAS INSTRUCCIONES E INFORMACIÓN ACERCA PASO 1: Montaje mural del calentador PASO 2: Cláusulas de cableado/Cableado DE LA SEGURIDAD. 1. Ubique los puntales de la pared que estén más cerca de Esta unidad calentadora está diseñada para una los cables de suministro y luego coloque el calentador instalación permanente.
  • Página 9: Funcionamiento Y Mantenimiento

    PASO 3: Termostato ¡ADVERTENCIA! Para obtener mejores resultados, use un termostato mural electrónico Cadet o un juego de termostato DPST de tapa extrema Riesgo de EBKN. Se recomienda contar con un termostato para cada habitación. La ubicación de termostato se debe determinar electrocución.
  • Página 10: Tabla De Resolución De Problemas

    GARANTÍA LIMITADA DE UN AÑO: Cadet Manufacturing Co. reparará a otro. Cadet no asume ni autoriza a nadie que lo haga en su o reemplazará todo producto Cadet, incluyendo termostatos, que se nombre, ninguna otra obligación o responsabilidad en relación con...

Tabla de contenido