Cadet EBHA Serie Manual Del Usuario

Features & Benefits
3 1 / "
4
• Whisper quiet operation and low surface
8,26
temperatures
• Filled with 80% water 20% Ethylene Glycol
• Self-contained hermetically sealed element design
requires no plumbing, piping, or other water supply
• Higher fluid capacity offers better heat retention,
which creates less cycling and keeps more consistent
room temperatures
• Designed to reduce the effects of indoor allergens
• 5-year element warranty
WARNING
Turn the electrical power off at the electrical
panel board (circuit breaker or fuse box) and lock
or tag the panel board door to prevent someone from
turning on power while you are working on the
heater. Failure to do so could result in serious
electrical shock, burns, or possible death.
1. Read all information labels. Verify that the
electrical supply wires are the same voltage as the heater.
2. All electrical work and materials must comply with the
National Electric Code (NEC), the Occupational Safety and
Health Act (OSHA), and all state and local codes.
3. The heater must be grounded to the grounding screw terminal.
4. If you need to install a new circuit or need additional wiring
information, consult a qualified electrician.
5. Protect electrical supply from kinks, sharp objects, oil,
grease, hot surfaces or chemicals.
6. Do not install any baseboard heater below an electrical
outlet.
TEL: 360-693-2505 Fax: 360-694-8668 P.O. Box 1675 Vancouver, WA 98668-1675
The EBHA
OWNER'S GUIDE
Important Information
Save These Instructions
7. WARNING
Overheating or fire may occur. DO NOT place the heater
behind doors.
8. WARNING
Fire or explosion may occur. DO NOT place heater in any
area where combustible vapors, gases, liquids, or excessive
lint or dust are present.
9. WARNING
Risk of Electrical Shock. Turn off all power at the electrical
panel board supplying power to the heater before doing
any electrical wiring.
10. WARNING
Risk of Fire. Heater must be kept clear of all obstructions:
maintain a 12" minimum clearance in front and above the
heater with a 6" minimum on each side. Heaters must be kept
clean of lint, dirt and debris. (See Maintenance
Instructions)
11. WARNING! Element filled with heat transfer fluid containing
20% Ethylene Glycol and 80% water. In the unlikely event of
leakage, if consumed, call your local poison control center
or seek medical attention immediately.
Models:
EBHA500
EBHA750
EBHA1000
EBHA1380
EBHA1500
EBHA500-8
EBHA750-8
EBHA1000-8
EBHA1380-8
EBHA1500-8
Tools Required:
Phillips Screwdriver
Straight Screwdriver
Wire Strippers
Drill or Hammer
Level
Punch or Chisel
Drill Bits
Utility Knife
4 Wood Screws
3 Wire Nuts
1 Strain Relief Connector