Electrical Installation; Circuit Diagram - Pahlen Jet Swim 2000 Manual

Jet Swim 2000
Safety
The jet stream is powerful, which is why one should not be closer than 0.5 m from the stream outlet for a protracted period.
People with long hair should pay careful attention so that their hair does not get stuck in the intake (the perforated openings
under the stainless steel front).
Small children should not be in the pool without supervision, especially not when the Jet Swim device is in operation.
Always inform all the other bathers in the pool before starting the Jet Swim.
Always check that the current to the pump is disconnected before commencing any work, service or maintenance
of the pump
CENELEC* members:
Note! The appliance can be used by children from the age of 8 and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge, if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
* CENELEC members are: Austria, Belgium, Bulgaria, Croatia, the Czech Republic, Denmark, Estonia, Finland, Germany, Greece, Hungary,
Iceland, Ireland, Italy, Latvia, Lithuania, Lucembourg, Malta, the Netherlands, Norway, Poland, Romania, Slovakia, Slovenia, Spain, Sweden,
Switzerland, Turkey and the United Kingdom.
Other countries than CENELEC members (according to IEC):
Note! This appliance is not intendend for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the
use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play
with the appliance.

Electrical Installation

All electrical connections shall be made by an authorised electrician.
The device shall be fitted with a residual current device with max breaking capacity 30mA.
The pump motor is connected via the control box for Jet Swim 2000, see the circuit diagram. Check the rating plate on the
pump motor for the correct connection on the closing link.
Make sure that the pump motor has been connected in the correct direction of rotation (see the rotation direction arrows on
the pump motor). The wrong direction can damage the pump.
N.B.! The pump must never be started without being filled with water.
Make sure that the motor protection in the control panel is set according to the rated current; see the rating plate.

Circuit Diagram

3~400/460V
2,5~D
Pressure
switch
B1
P K1
F1
W2 U2 V2
M1
U1 V1 W1
Connector
PE
Motor
protection
relay
M
3~230/265V
Micro
switch
F2
1,5~D
K1
Pressure
switch
B1
P
F1
W2 U2 V2
U1 V1 W1
7
ENGLISH
2,5~D
Connector
PE
Motor
protection
relay
M1
M