Replacing Your Filters; Trouble Shooting Tips - Hunter HEPA Manual Del Usuario

REPLACING YOUR FILTERS:

We recommend periodical filters checking and replacing for optimal
performance.
‡ 7KH (FR6LOYHU SUHILOWHU VKRXOG EH UHSODFHG DIWHU DSSUR[LPDWHO\  PRQWKV
When the pre-filter timer light is illuminated, you should replace with the new
Eco-Silver pre-filter.
‡ 7KH +(3$ ILOWHU VKRXOG EH UHSODFHG DIWHU DSSUR[LPDWHO\  PRQWKV :KHQ WKH
HEPA filter timer light is illuminated, you should replace with the new HEPA
filter.
Replace Eco-Silver pre-filter & HEPA filter
Remove any packaging and plastic bag from the new filters before
replacement.
1. When the pre-filter or HEPA filter light is illuminated, you should open the
front grill and replace the filter.
2. When you change the filter, press the reset icon
3. Turn the air purifier OFF and unplug it from the power outlet.
4. Press the oval buttons on each side of the unit to release the grill. While,
lifting up and away from the unit, remove the grill. Figure 1 & figure 2.
5. Remove and discard the filter.
6. Set new filter into the air purifier. Ensure the filter is seated fully into the unit
by pressing all four corners of the lifter. Figure 3.
7. Install the front grill by engaging its tabs into the bottom slots on the unit.
Figure 5. Then swing grill up and gently push in top to snap into place.
Figure 6.
8. Plug the air purifier into an outlet for operation.
IMPORTANT: Do not use water, any liquid or detergents to clean the filter. DO
NOT attempt to wash the filter as damage to the filter or air purifier may occur.

TROUBLE SHOOTING TIPS

Unit does not operate:
If the air purifier shuts off unexpectedly, safety features may be activated to
prevent damage or injury. If this happens, check the following:
1. Is the air purifier plugged into a working electrical outlet?
2. Is the HEPA filter correctly located in place?
3. Has a household fuse blown, or has a circuit breaker tripped? Replace the
fuse or reset the circuit breaker. If the problem continues, call an electrician.
4. Was a regular fuse used? Use a time-delay fuse or time-delay circuit
breaker.
.
10