Compressed Air Supply - Monti MBX Bristle Blaster 3500X Manual De Instrucciones

® ®
MBX
Bristle Blaster 3500X
6.

Compressed air supply

This compressed air tool is designed for a maximum flow pressure of 90 psi (6.2 bar) at the tool. On the usage of the
® ®
MBX Bristle Blaster 23 mm belt, a flow pressure of 90 psi (6.2 bar) at the tool is necessary. On the usage of the
® ®
MBX
Bristle Blaster 11 mm belt, a flow pressure of 75 psi (5.2 bar) at the tool is necessary.
Correct air pressure will increase the service life!
The supply of compressed air must be free of water. For this reason a water separator must be used to trap conden-
sate. If the compressed air hose is too long, the tool cannot be supplied with the necessary air pressure.
For correct operation and the long service life of the compressed air motor, the usage of a lubrication device in the
compressed air line is expressly recommended.
Attention!
Use correct air pressure regulator!
®
Bristle Blaster belt
23 mm belt
11 mm belt
Attention!
On the usage of the compressed air regulator, a flow pressure of 7.5 - 8.5 bar at the tool is necessary!
All manuals and user guides at all-guides.com
Colour of compressed air
regulator
Silver (article number ZU-071)
Blue (article number ZU-070)
Operating instructions
GB
17