Safety Labels - Baja BAi911LP Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate the product better and safer.
SYMBOL
V
Volts
A
Amperes
Hz
Hertz
W
Watt
hrs
Hours
gal
Gallon
qt
Quart

SAFETY LABELS

The information below can be found on the generator. For
your safety, please study and understand all of the labels
before starting the generator.
If any of the labels come off the unit or become hard to read,
contact customer service or a qualified service center for
replacement.
  You WILL be KILLED or SERIOUSLY HURT if you do not
follow the Operator's Manual instructions.
  Risk of Fire. Do not add fuel while the product is operat-
ing.
  Generator is a potential source of electric shock. Do not
expose to moisture, rain, or snow. Do not operate with
wet hands or feet.
  Exhaust contains poisonous carbon monoxide gas that
can cause unconsciousness or DEATH. Operate in well-
ventilated, outdoor areas away from open windows or
doors.
  Do not expose to rain or use in damp locations.
  Using a generator indoors CAN KILL YOU IN MINUTES.
Generator exhaust contains carbon monoxide. This is a
poison you cannot see or smell.
  NEVER use inside a home or garage, EVEN IF doors and
windows are open.
  Only use OUTSIDE and far away from windows, doors,
and vents.
SYMBOLS
NAME
Voltage
Current
Frequency (cycles per second)
Power
Time
Volume
Volume
7 — English
DESIGNATION/EXPLANATION
CLEARANCE WARNING
While operating and storing, keep at least 3 feet of clearance
on all sides of this product, including overhead. Allow a mini-
mum of 30 minutes of "cool down" time before storage. Heat
created by muffler and exhaust gases could be hot enough
to cause serious burns and/or ignite combustible objects.
PROPANE CYLINDER WARNING
Never disconnect
the propane cylin-
der when the gen-
erator is running.
Shut off the engine
and allow the unit
to cool for at least
five minutes before
disconnecting the
cylinder.

Publicidad

Tabla de contenido
loading

Tabla de contenido