Carton Contents - sunjoe SWJ701E Manual Del Operador

Ocultar thumbs Ver también para SWJ701E:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Unpacking

Carton Contents

• Electric chain saw
• 18 in. (45.7 cm) cutting chain
• 18 in. (45.7 cm) guide bar
• Dual-tipped hex key wrench/blade screwdriver
• Cutting bar sheath
• Manual with registration card
1. Carefully remove the chain saw and check to see that all
of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe
+ Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use your new electric chain
saw. The packaging is made of recyclable materials.
Properly dispose of these materials in accordance with
local regulations.
IMPORTANT! The equipment and packaging material are not
toys. Do not let children play with plastic bags, foils or small
parts. These items can be swallowed and pose a suffocation
risk!
Assembly
m
WARNING!
Always wear heavy-duty gloves when
handling the bar and chain. Mount the bar and chain very
carefully so as not to impair the safety and efficiency of the
machine. If in doubt, contact an authorized Snow Joe
Sun Joe
dealer or call the Snow Joe
®
service center at 1-866-SNOWJOE (1-866-766-9563).
m
WARNING!
Unpacking and assembly should be
completed on a flat and stable surface, with adequate space
for moving the machine and its packaging.
m
DANGER!
Never start the motor before installing the
guide bar, chain, and end cover. Without all these parts in
place, the clutch/sprocket can fly off or explode, exposing the
user to potentially serious injuries.
m
WARNING!
To avoid serious personal injury, read and
understand all safety instructions provided.
m
WARNING!
Before performing any maintenance, make
sure the tool is unplugged from the power supply. Failure to
heed this warning could result in serious personal injury.
customer service center at
®
+
®
+ Sun Joe
customer
®
®
Installing the Guide Bar and Chain
Tools and supplies required:
• Dual-tipped hex key wrench/blade screwdriver (supplied)
• Heavy-duty work gloves
NOTE: When replacing the guide bar and chain, use only
identical replacement parts. Make sure the chain saw is
disconnected from the power supply before proceeding with
installation.
1. Using the supplied flat-tip blade screwdriver, remove the
end cover nut cap from the chain/sprocket end cover to
expose the end cover nut (Fig. 1).
2. Using the supplied hex key wrench, unscrew the end
cover nut and remove the chain/sprocket end cover
(Fig. 1).
Fig. 1
End cover
Hex key wrench
3. Lay out the new saw chain in a loop and straighten any
kinks. THE SHARP SIDE OF THE TEETH MUST FACE
AWAY FROM YOU AND IN THE DIRECTION OF THE
CHAIN ROTATION INDICATED ON THE GUIDE BAR. If
the teeth face backwards, turn the loop over (Fig. 2).
Fig. 2
8
End cover nut cap
End cover nut

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido