Tomy The First Years H220 Manual De Instrucciones página 5

Section 4 - High Chair Assembly - continued
Assembly:
3. Attach Legrest:
A. Rotate legrest upright to allow tabs to enter
desired hole height.
B. Rotate legrest down to snap into place.
C. To change position of the legrest, rotate
legrest out and snap into desired position.
4. Attach seat pad and harness:
A. Place seat pad onto seat.
B. Pull shoulder harness through slot in seat pad.
Push shoulder harness strap ends through
the slot in the seat back. Repeat for the waist
harness.
Note: check the back of the seat to
ensure the ends of the webbing are
through the slot. Pull on the straps
to ensure that it is tight.
7
Section 4 - High Chair Assembly - continued
C. Push crotch strap through hole in seat pad.
Push crotch strap end through the slot in the
seat.
Note: Ensure the crotch strap end is
through by checking the bottom of the
seat.
D. Pull elastic and wrap around tab. Repeat for
opposite side.
5. Assembly - Tray:
A. Snap on tray by dropping down onto the
armrests until both sides are securely
attached.
8