Warnings And Error Messages - WOLFF FRÄSMASTER 18V Instrucciones De Funcionamiento

Accessories
The FRÄSMASTER 18V can be equipped with a tungsten carbide or PCD cutter blade. Only perforated,
original WOLFF cutter blades may be used.
Cutter blade geometry

Warnings and error messages

Battery level:
The indicator goes off after five seconds. If any of the LED lights are flashing, it means that the battery
needs charging. If no LED lights illuminate when you press the button, it means that the battery is defective
and has to be replaced.
NOTE
If the display flashes after you insert the battery into the charger, either the battery or the charger is
faulty.
Display flashes slowly and backlight is orange.
The battery is too hot or too cold. The charging operation will commence as soon as the
battery has reached the charging temperature (0°C–50°C).
Display flashes quickly and backlight is red.
Remove the battery from the charger and then reinsert it. If the display remains the same,
the battery is defective. Replace the battery or have it checked by a specialist.
If this error is still indicated when you insert a different battery, it means that the charger is
defective. Have the charger checked by a specialist.
42 42
Order number
PCD cutter blade
Ø 130 x 3.5
089658
Tooth profile: Conical
Number of teeth: 6
Tungsten carbide cutter blade
Ø 130 x 2.8
089625
Tooth profile: Parabolic
Number of teeth: 12
Tungsten carbide cutter blade
Ø 130 x 3.5
089623
Tooth profile: Parabolic
Number of teeth: 12
Designation