Connections To Receiver - Carson Reflex Stick PRO 3.1 LCD Indicaciones De Seguridad

CONNECTIONS TO RECEIVER

Battery eliminator is installed in the receiver circuitry.
NiMH battery from 6 V to 11 V can be used for the receiver. Batteries
of higher voltage may damage the receiver and servos.
Electronic speed controller
(not included)
Receiver
Do not connect a separate power supply
to the receiver!
GB // 20
ATTENTION!
high-current servos must be used!
Additional
channels
ATTENTION
Make sure that male and female
connectors have the correct polarity!
If the input voltage is above 6 V, appropriate
Connector motor
Connector battery
Power switch On-/Off
Steering servo
Channel 1
(not included)