Fail Safe Adjustment; Binding The Transmitter And Receiver; Specifications - Carson Reflex Stick PRO 3.1 LCD Indicaciones De Seguridad

FAIL SAFE ADJUSTMENT

1. Set the throttle and the steering stick to the neutral position.
2. Turn on the transmitter and receiver.
3. Press the F/S SET button, the LED on the receiver will start to
flash.
4. Put the throttle trigger at the brake position, press the "F/S SET"
button, the LED should become solid.
5. For electric models, put the throttle trigger at the neutral posi-
tion when you are making the failsafe setting.

BINDING THE TRANSMITTER AND RECEIVER

1. Turn on the receiver power. Press the SW
switch. The receiver's LED should start
flashing.
ATTENTION
Keep the transmitter and receiver not over 40 cm
apart when setting and binding.

SPECIFICATIONS

Transmitter
Receiver
It is CARSON's policy that we strive to improve the quality of our products. Therefore CARSON may alter specifications of our products at
any time without any notice.
Reflex Stick Pro 3.1 LCD:
As soon as the receiver/transmitter signal is interrupted, the
receiver switches into the preset throttle failsafe setting.
2. Turn on the transmitter.
During the binding process no other transmit-
ter should be operated in the vicinity at the
same time!
Frequency 2.4 GHz
Power supply DC 4.8 - 6 V=
Power Supply DC 6.0~11.0 V
Dimensions 35 x 26 x 14 mm
3. When the LED on the receiver
becomes solid, the binding process
is completed.
27 // GB