Publicidad
Terminator
1.
Locate bus connection (HPT and FP only)
and cable as shown. Cut end of cable at
angle to aid in piercing grommet. Leave
additional cable for expansion loop. See
page 5 for multiple cable installation tips.
4.
Slide expediter toward pipe and route
cable through support base entry.
7.
Cut off end of cable.
ZT-P-XP
TM
GRW
2.
For HPT and FP cable, exchange grommet
in Terminator with grommet provided in
PETK-3-ZT.
5.
Insert banding guide into expediter and
snap into place.
8.
Terminate cable with appropriate PETK
termination kit. Refer to PETK installation
instructions. Push excess cable back
through expediter. Tighten cap securely.
Tape cable expansion loop to pipe.
INSTALLATION PROCEDURES
GRW-G/Tstat
3.
6.
9.
3
Insert cable into expediter. If mounted on
bottom or side of pipe, punch out weep
hole.
Mount expediter to pipe using pipe band.
Do not band over cable.
Remove expediter from pipe by removing
pipe band.
Publicidad
