LiftMaster myQ CAPAC Manual De Instrucciones página 2

Gate Access
NOTE: The SDA/SLA
Gate input/output shall
not be connected in UL
applications.
PRIMARY RELAY
GATE OPERATOR
Refer to the Gate Operator manual
for wiring details.
NOTE: For UL installations, only a
UL 325 Listed Gate Operator, UL
294 Listed electric door strikes or
UL 294 Listed Maglocks may be
connected to relay output 1 or 2.
OUTPUT WIEGAND
1 2
OUTPUT
GATE
SDA SCL NO COM NC NO COM NC
EXIT
AUXILIARY RELAY
Low
Voltage
Power
Supply
Isolation
Relay
NORMALLY OPEN
Not responsible for conflicts between the information listed in
the wiring diagram and the requirements of your local building
codes. The information is for suggested use ONLY. Check your
local codes BEFORE installation.
INPUT
1 2
WIEGAND INPUT
D1 COM D0 D1 COM D0 1 GND 2
LIGHT
LOAD
LINE
OR
OR
ALARM BYPASS
COMMON
POWER
GND 12V-24V
POWER ETHERNET
STATUS
EOL (End of Line)
Resistor (1k ohm)
GATE OPERATOR
(connect to Aux
Closed Limit switch -
refer to gate operator
manual)
*AUXILIARY RELAY
For AC Power:
Install a Siemens S10K30MOV
(Metal Oxide Varistor) (provided)
or equivalent
NORMALLY CLOSED Use 18-22 AWG
COMMON
Power for Maglock
(Not Provided)
DO NOT use the power
supply for the controller
MAGLOCK
–
For DC Power:
Install a 1N4005
diode or equivalent