Door Access - LiftMaster myQ CAPAC Manual De Instrucciones

Door Access

DO NOT INSTALL THE SYSTEM IN THE FAIL SECURE MODE
UNLESS PERMITTED BY THE LOCAL AUTHORITY HAVING
JURISDICTION. Doing so may cause interference with the
operation of panic hardware.
*PRIMARY RELAY
DOOR STRIKE
Use 18-22 AWG
For DC Power:
Install a 1N4005
diode or equivalent
Use 18-22 AWG
For DC Power:
Install a 1N4005
diode or equivalent
OUTPUT
1
OUTPUT
GATE
SDA SCL NO COM NC NO COM NC
For AC Power:
Install a Siemens
S10K30MOV
(Metal Oxide Varistor)
(provided) or equivalent
Power for Door Strike
(Not Provided)
COMMON
+
NORMALLY OPEN
OR
MAGLOCK
For AC Power:
Install a Siemens S10K30MOV
(Metal Oxide Varistor) (provided)
or equivalent
NORMALLY CLOSED
COMMON
+
Power for Maglock
(Not Provided)
DO NOT use the power
supply for the controller
Not responsible for conflicts between the information listed in
the wiring diagram and the requirements of your local building
codes. The information is for suggested use ONLY. Check your
local codes BEFORE installation.
WIEGAND INPUT
2 1 2
WIEGAND
D1 COM D0 D1 COM D0
INPUT POWER
1 GND 2 GND 12V-24V
POWER
SUPERVISED (DOOR STATUS)
DOOR SENSOR
(NON-SUPERVISED)
EOL (End of Line) Resistor
AUXILIARY RELAY
LIGHT
Low
Voltage
Power
Supply
LOAD
Isolation
LINE
Relay
OR
ALARM BYPASS
COMMON
NORMALLY OPEN
ETHERNET
DOOR SENSOR
OR
(SUPERVISED)
(1k ohm)
NOTE: For UL
installations, only UL
294 Listed electric
door strikes or UL
294 Listed Maglocks
may be connected to
relay output 1 or 2.