Publicidad
Idiomas disponibles
Idiomas disponibles
• Slide the gate jamb on to the fence
panel and place the hinges in the
center of the fence rail. Using the
hinge as a guide, drill the four (4)
necessary ¼" holes for the hinge
bolts. Ensure the rails are fully
inserted in the jamb before
drilling. The bolts need to go
through the jamb and rail to function
properly. See Fig. 3.
• Insert the bolts and loosely attach
the nuts (these will be tightened later).
Duplicate for each of the four
corners. Once all corners are loosely
fastened, measure from corner-to-
corner to ensure the gate is square.
When square, tighten all bolts with a 7/16" wrench.
Do not over-tighten as it may crush the gate jambs. See Fig. 3.
Installing Gate
• Measure to be sure you can install the gate to the post with
approximately a 2" gap from the ground to the bottom of
the panel. Align the rails on the gate to the rails on the fence
panels.
• Hang the gate between the posts. Use a 5/8" spacer between
the gate and the posts. See Fig. 4. Secure in place with shims
under the gate or clamp the jamb on the gate to the post.
Make sure the gate is level and square. Attach hinge brackets
to the gate post with the provided screws. See Fig. 5.
• Remove any clamps and shims. Attach latch using screws
provided. See Fig. 6.
• Install a post cap on each post using PVC cement or an
exterior adhesive.
Note: The Dover gate latch is designed to
be used on the left or right hand side of the
gate, depending on customer preference
or design. The latch is assembled, ready
to be installed on the right hand side of
the gate. If you desire to switch the latch
follow these simple steps:
• Remove the 2 shoulder bolts and spring.
• Change orientation of the clicker
• Re-attach spring and insert shoulder bolts.
• Shoulder bolts must be fully tightened.
Thread locking adhesive is recommended.
Customer Service
877-463-8379
www.ufpi.com
The diagrams and instructions shown are for illustration purposes only and are not meant to replace a licensed professional. Any construction or use of the product must be in
accordance with all local zoning and/or building codes. The consumer assumes all risks and liability associated with the construction or use of this product. The consumer or
contractor should take all necessary steps to ensure the safety of everyone involved in the project, including, but not limited to, wearing the appropriate safety equipment.
EXCEPT AS CONTAINED IN THE WRITTEN LIMITED WARRANTY, THE WARRANTOR DOES NOT PROVIDE ANY OTHER WARRANTY, EITHER EXPRESS OR IMPLIED, AND SHALL
NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.
© 2012 Universal Forest Products, Inc. All rights reserved. 5784 Dov_2/12
fig. 5
Fig.4 DoverGateSpacer.ai
Striker
Fig.6 DoverLatch.ai
fig. 3
5/8
fig. 4
Latch
fig. 6
Publicidad
