maniquick MQ090 Instrucción Para El Uso página 45

CONDITIONS FOR SERVICE UNDER GUARANTEE
1. SANICO Srl guarantees the absence of faults and mechanical defects and the
completeness of the product when it is sold.
2. Repairs can be done only at Service Centres authorized by SANICO Srl or by the Autho-
rized Distributor in the country where you have purchased the appliance.
3. The duration of the period of guarantee on the materials and on manufacturing and op-
erating defects is 2 years with effect from the date of sale, subject to all the
conditions for the Purchaser shown in the Instructions for use. The obligations of
guarantee do not cover expendable materials: electrode cups, elastic bands, power
supply cables etc..
4. Complaints relative to the product must be presented directly to the authorized service
centre. The service centre, on the basis of an agreement with the Vendor, is competent to
establish the cause and nature of the fault. The product will be replaced only if it cannot
be repaired.
5. The owner of the product will provide autonomously for delivering and collecting the
product from the place of the repair under guarantee.
6. The time necessary for the repair under guarantee will be subject to the degree of
seriousness of the fault.
7. The responsibility of SANICO Srl under these conditions of guarantee will be limited to
the amount paid by the Purchaser for the product in question.
The guarantee on the product will not be applied in the following cases
• certificate of guarantee filled in incorrectly or falsified; serial number (if applicable for the
specific product) damaged or removed;
• absence of commercial and financial documents (cash receipt, delivery note)
proving the purchase;
• opening or repair of the product by the Purchaser or by an unauthorized Service
Centre;
• defects following failure by the Purchaser to observe the rules for use, storage and
transport of the product shown in the relative technical and regulations documentation,
in which case the regulations of the aforementioned documentation which have been in-
fringed must be specified;
• penetration of foreign bodies or liquids inside the product;
• presence on the product of internal or external mechanical defects (cracks, signs of a fall,
chipped parts, etc.) consequent to the incorrect use, installation or transport of the product;
• components or accessories subject to rapid wear and tear (electrode cups, elastic
bands);
• defects caused by external agents (dirt visible externally and internally, traces of corro-
sion);
• defects due to causes independent of the manufacturer, such as power supply voltage
step changes, natural phenomena or disasters, fires, actions by animals, insects etc.
• complaints for defects found by the Purchaser that are made after the expiry of the
guarantee period or any other period established by the law for reporting any defects;
• use of the product by the Purchaser not for personal (domestic) use but for commercial
and profit-making purposes.
45